First Gen Miata Widebody Kit with Racing Beat Bumpers

This page shows our first gen Miata, 1990-97 Wide Body Kit. It consists of four flares that are designed to be bonded into the stock fenders and 4 flare extensions that bond to the original or aftermarket bumpers. This is the only way to install flares on the rear as the rear fenders cannot be removed. This also keeps the kit legal for use in SM2. Small extensions are included for the bumper at each corner. A bolt-on front fender set may be coming along later although it will still require bonding for the rear and the bumpers. (Racing Beat Bumpers are shown on this page.)

The bumper extensions are intended for use on stock bumpers, but aftermarket bumpers that are similar to the stock ones will also work. The extensions start from approximately halfway through the side marker lights.

The best part is that this kit is thick enough for daily use. Run big rubber or simply give your car the stance to back up an FM II or Ubercharger powerplant.