Our 1st gen Miata body kit is now available. It consists of four flares that are designed to be bonded into the stock fenders and 4 flare extensions that bond to the original or aftermarket bumpers. This is the only way to install flares on the rear as the rear fenders cannot be removed. This also keeps the kit legal for use in SM2. Small extensions are included for the bumper at each corner. A bolt-on front fender set may be coming along later although it will still require bonding for the rear and the bumpers.
The bumper extensions are intended for use on stock bumpers, but aftermarket bumpers that are similar to the stock ones will also work. The extensions start from approximately halfway through the side marker lights.
The best part is that this kit is thick enough for daily use. Run big rubber or simply give your car the stance to back up an FM II or Ubercharger powerplant. The price for the complete kit is $999 plus shipping. It is available immediately through Flyin' Miata.The kit is available from the AWR Store or through Flying Miata. |
| Miata Wide Body Kit by AWR |
| Installation Page 1 | Installation Page 2 | Finished Gallery Page 1 | Finished Gallery Page 2 |
View a flash version of this slideshow by clicking here.
 |
 |
 |
 |
| This angle gives a good idea of the rear bumper extensions. |
P1010017.JPG
|
P1010018.JPG
|
P1010019.JPG
|
|
